—— 朗菲电气·您的! ——

产品中心
相序保护器系列 时间继电器 温度控制器 电动机保护器 交流接触器系列 热过载继电器系列 整流器系列 高低压电气元器件

产品详情

适用范围 Applicable scope

       CJX2系列交流接触器(以下简称接触器)适用于交流50Hz或60Hz、电压至660V、电流至95A的电路中,供远距离接通与分断电路及频繁起动、控制交流电动机,接触器还可组装成积木式辅助触头组、空气延时头,机械联锁机构等部件,组成延时接触器、可逆接触器、星三角起动器并且可以和热继电器直接插接安装组成电磁起动器。

       CJX2 series AC contactor (here in after referred to as contactor) for AC 50Hz or 60 Hz, the voltage to 660V, current to 95A Circuit, for remote connection and breaking circuit and frequent start, control AC motor, contactor can also be assembled into a modular auxiliary contact group, Air delay head, mechanical interlock mechanism and other components, composed of delay contactor, reversible contactor, star delta starter and can and thermal relay Directly connected to form an electromagnetic starter.


型号及其含义 Model and its meaning

1.jpg


主要技术参数 The main technical parameters

2.jpg


正常工作条件和安装条件 Normal working conditions and installation conditions

◇周围空气温度为:-5℃~+40℃,24小时内其平均值不超过+35℃。

◇海拔:不超过2000m。

◇大气条件:在+40℃时大气相对湿度不超过50%,在较低温度下可以有较高的相对湿度,湿月的平均低温度不超过+25℃,该月的平均相对湿度不超过90%。并考虑因温度变化发生在产品上的凝露。

◇污染等级:3级。

◇安装类别:III类。

◇安装条件:安装面与垂直面倾斜度大于±50°。

◇冲击振动:产品应安装和使用在无摇动,冲击和振动的地方。

◇ The ambient air temperature is: -5℃ ~ +40℃, 24hours its average does not exceed +35℃.

◇ Elevation: no more than 2000 meters.

◇ Atmospheric conditions: At +40℃ when the relative humidity of not more than 50%, at a lower temperature can have a higher relative humidity, the wettest month average minimum temperature does not exceed +25℃, the average monthly maximum relative Humidity does notexceed 90%. And consider the occurrence of temperature due to condensation on the product.

◇ Pollution Level: 3 level.

◇ Installation category: III category.

◇ Installation Conditions: the installation surface and the vertical slope of more than ± 50°.

◇ Shock Vibration: The product should be installed and used where there is no significant shaking, shock and vibration.


外形及安装尺寸 Shape and installation dimensions

3.jpg

4.jpg


订货须知 Ordering instructions

订货时必须指出:

○接触器完整的型号名称。

○线圈的额定工作电压和频率。

○订货台数。

○如需订购标准卡轨,应另行注明。

订货示例:CJX2-09线圈电压220V、50Hz、10台。

When ordering, you must point out:

○ Contactor complete model name.

○ Rated operating voltage and frequency of coil.

○ Order number.

○ If you need to order the standard rail, please specify separately.

Order example: CJX2-09 coil voltage 220V, 50Hz, 10 units.